I have been doing a lot of tinkering with linux based storage (more to come on that!) over the past few weeks and I had to hunt and peck around the internet to find all of the information on using bonding/lacp and vlans in linux so I want to bring it all to one place. All of these configuration files are from Ubnutu but the format should be similar in other distros. All of the switch configurations were on a Cisco 2960 running IOS 12.2-lanbase which is a fairly old and basic switch.

Today I had an entire datastore of VMs to register, probably about 30 in total, and I didn’t want to go through the GUI and register each VM manually.

I came up with this quick unix one-liner:

# NOTE: My datastore path is /vmfs/volumes/5317a80e-add165f6-ada9-001517599f73
# replace this with whatever datastore needs searching

#VMs
find /vmfs/volumes/5317a80e-add165f6-ada9-001517599f73 -name "*.vmx" -exec  vim-cmd solo/registervm {} \;

#Templates
find /vmfs/volumes/5317a80e-add165f6-ada9-001517599f73 -name "*.vtmx" -exec  vim-cmd solo/registervm {} \;

Just wanted to post a quick post about how to configure 802.3ad port consolidation with a Cisco switch and VMware ESX (vSphere was used for this example). I was using an HP DL380 with 2 onboard NIC and 2 24 port Cisco 3750G connected with stackwise cables.

Switch Configuration:

…
interface GigabitEthernet1/0/1
description ESX NIC 2
switchport trunk encapsulation dot1q
switchport mode trunk channel-group 1 mode on
end
…
interface GigabitEthernet2/0/14
description ESX NIC 2
switchport trunk encapsulation dot1q
switchport mode trunk channel-group 1 mode on
end
…
interface Port-channel1
description ESX PortChannel
switchport trunk encapsulation dot1q
switchport mode trunk
end
…